Download GCam 7 Astrophotography for Xiaomi Mi Max 3 (Nitrogen) by Arnova8G2 [GCam_7.0.009_DevMod_Arnova8G2_beta_4.0]

The Xiaomi Mi Max series don't really get as much love from Devs compared to other Xiaomi series like the Redmi Note or even the MI flagship series, and the Mi Max 3 is no exception. Although there are a couple of ROMs and Mods for the MI Max 3 but it is nothing compared to most other Xiaomi lineup.

The Mi Max 3 is a 2018 smartphone launched with a Snapdragon 636 chipset. The phone has a dual rear camera setup which consist of a primary 12MP sensor and a secondary 5MP sensor. There isn't many GCam that works great with the Mi Max 3 (Codename: Nitrogen) but there are a couple of compatible GCam apps.

The Beta GCam 7.0.009 by Arnova8G2 which is called "GCam_7.0.009_DevMod_Arnova8G2_beta_4.0" works great with the Mi Max 3. Most of GCam features like Portrait mode, Slow motion mode, Lens Blur mode, Motion photos, and also Night Sight mode also works properly. 


How to install GCam on MI Max 3 (Nitrogen):

• Make sure you have Camera2 API enabled already or follow the instructions in this LINK.
• After that uninstall any current version of GCam on your phone (optional).
• Download the GCam 7.0.009 beta by Arnova8G2 from the link below.
• Install and launch the App, 
• Then you can start snapping.

Note: If you were unable to enable Camera2 API with the method above, then try out the method below instead.

Disclaimer: The procedure below might brick your phone if not followed accordingly. XiaomiAuthority will not be held responsible for any damage done to your phone. Make sure you backup your files and have a backup of your stock ROM before proceeding.

How to Enable camera2 API on Mi Max 3 (Nitrogen)

• Make sure your bootloader is unlocked and phone is rooted. Check the guide HERE.
• Download BuildProb Editor from this LINK.
• Launch the App and grant it root permission.
• Add the lines of code in the "Persist" part of your build.prob

persist.camera.HAL3.enabled=1
persist.camera.eis.enable=1
persist.camera.is_mode=4
persist.camera.stats.test=5
persist.vendor.camera.HAL3.enabled=1
persist.vendor.camera.eis.enable=1
persist.vendor.camera.is_mode=4
persist.vendor.camera.stats.test=5

• Save and restart.
• After restarting, you can go ahead and check if Camera2 API has been enabled by downloading Camera2 Prob Here (The Level_3 will turn green if it has been enabled).

Download GCam 7.0.009 astrophotography for MI Max 3 (Nitrogen) by Arnold8G2

• Download GCam_7.0.009_DevMod_Arnova8G2_beta_4.0.apk (LINK 1)
• Download GCam_7.0.009_DevMod_Arnova8G2_beta_4.0.apk (LINK 2)